ASTM D8172-18
Standard Test Method for Shear and Peel Strength of Solvent-Welded Seams with Nonreinforced Geomembranes

Standard No.

ASTM D8172-18

Release Date

2018

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM D8172/D8172M-18(2023)e1

Latest

ASTM D8172/D8172M-18(2023)e1

Scope

1.1 This test method describes destructive quality control and quality assurance tests used to determine the integrity of geomembrane seams produced by adhesive and chemical fusion methods. These test procedures are intended for nonreinforced geomembranes only. This test method utilizes two sampling techniques; Method A is for seams produced without a testing flap, while Method B is for seams that produce a testing flap. 1.2 The rationale behind the two methods is that most seaming processes produce some type of flap on the back side or front side, or both, of the seam to perform peel testing. However, there are some processes in the industry that do not produce any type of flap to perform seam peel testing, and this is where the additional method is needed. 1.3 This method is intended for use with polyvinyl chloride (PVC)-based material seams, but is not limited to PVC. 1.4 Units—The values stated in either SI units or inchpound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. 1.5 Hazardous Materials—Always consult the proper Material Safety Data Sheets for any hazardous materials used for proper ventilation and protection. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D8172-18 Referenced Document

• ASTM D4439 Standard Terminology for Geosynthetics*， 2024-02-01 Update
• ASTM D76/D76M Standard Specification for Tensile Testing Machines for Textiles*， 2021-07-01 Update

ASTM D8172-18 history

• 2023 ASTM D8172/D8172M-18(2023)e1 Standard Test Method for Shear and Peel Strength of Solvent-Welded Seams with Nonreinforced Geomembranes
• 2018 ASTM D8172-18 Standard Test Method for Shear and Peel Strength of Solvent-Welded Seams with Nonreinforced Geomembranes