ASTM C1183/C1183M-13(2018) PDF

Scope: 1.1 This test method covers two laboratory procedures for determining the extrusion rate of elastomeric sealants for use in building construction. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 There is no known ISO equivalent to this test method. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM C1183/C1183M-13(2018) Referenced Document

ASTM C717 Standard Terminology of Building Seals and Sealants*， 2019-03-01 Update
ASTM D1475 Standard Test Method For Density of Liquid Coatings, Inks, and Related Products
ASTM D2452 Standard Test Method for Extrudability of Oil- and Resin-Base Caulking Compounds

2018 ASTM C1183/C1183M-13(2018) Standard Test Method for Extrusion Rate of Elastomeric Sealants
2013 ASTM C1183/C1183M-13 Standard Test Method for Extrusion Rate of Elastomeric Sealants
2004 ASTM C1183-04(2008) Standard Test Method for Extrusion Rate of Elastomeric Sealants
2004 ASTM C1183-04 Standard Test Method for Extrusion Rate of Elastomeric Sealants
1991 ASTM C1183-91(1997) Standard Test Method for Extrusion Rate of Elastomeric Sealants