ASTM E2486/E2486M-22 PDF

Scope: 1.1 This test method covers a procedure for rapidly deforming by impact an EIFS for evaluating the effect of such deformation. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and to determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM E2486/E2486M-22 Referenced Document

ASTM D2794 Standard Test Method for Resistance of Organic Coatings to the Effects of Rapid Deformation (Impact)*， 2024-01-25 Update
ASTM E2110 Standard Terminology for Exterior Insulation and Finish Systems (EIFS)
ASTM E631 Standard Terminology of Building Constructions

2022 ASTM E2486/E2486M-22 Standard Test Method for Impact Resistance of Class PB and PI Exterior Insulation and Finish Systems (EIFS)
2018 ASTM E2486/E2486M-13(2018) Standard Test Method for Impact Resistance of Class PB and PI Exterior Insulation and Finish Systems (EIFS)
2013 ASTM E2486/E2486M-13 Standard Test Method for Impact Resistance of Class PB and PI Exterior Insulation and Finish Systems (EIFS)
2006 ASTM E2486-06 Standard Test Method for Impact Resistance of Class PB and PI Exterior Insulation and Finish Systems (EIFS)