This standard specifies the test principle, test equipment, samples, test procedures and test reports of the metal pipe bending test method. This standard applies to the determination of the full-section bending plastic deformation capacity of circular cross-section metal pipes with an outer diameter not greater than 65 mm. The outer diameter range of metal pipes applicable to this standard can be specified in more detail in relevant product standards. Note: The bending test of the metal pipe transverse strip sample is carried out according to GB/T232 [1], in order to increase the original bending rate of the sample. 2 Symbols, names and units
GB/T 244-2020 history
2020GB/T 244-2020 Metallic material—Tube—Bend test method