ASTM E2602-22 PDF

Scope: 1.1 These test methods describe the assignment of the glass transition temperature of materials using modulated temperature differential scanning calorimetry (MTDSC) over the temperature range from –120 °C to +600 °C. The temperature range may be extended depending upon the instrumentation used. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM E2602-22 Referenced Document

ASTM E1142 Standard Terminology Relating to Thermophysical Properties
ASTM E1356 Standard Test Method for Assignment of the Glass Transition Temperatures by Differential Scanning Calorimetry or Differential Thermal Analysis
ASTM E1545 Standard Test Method for Assignment of the Glass Transition Temperature by Thermomechanical Analysis*， 2022-04-01 Update
ASTM E1640 Standard Test Method for Assignment of the Glass Transition Temperature By Dynamic Mechanical Analysis
ASTM E473 Standard Terminology Relating to Thermal Analysis
ASTM E967 Standard Practice for Temperature Calibration of Differential Scanning Calorimeters and Differential Thermal Analyzers
ASTM E968 Standard Practice for Heat Flow Calibration of Differential Scanning Calorimeters

2022 ASTM E2602-22 Standard Test Methods for Assignment of the Glass Transition Temperature by Modulated Temperature Differential Scanning Calorimetry
2009 ASTM E2602-09(2015) Standard Test Methods for the Assignment of the Glass Transition Temperature by Modulated Temperature Differential Scanning Calorimetry
2009 ASTM E2602-09 Standard Test Method for the Assignment of the Glass Transition Temperature by Modulated Temperature Differential Scanning Calorimetry