ASTM E128-99(2019) PDF

Scope: 1.1 This test method covers the determination of maximum pore diameter and permeability of rigid porous filters used in the laboratory for filtration or diffusion. They are applicable to filters made of sintered glass, ceramic, metal, or plastic. This test method establishes a uniform designation for maximum pore diameter and also provides a means of detecting and measuring changes which occur through continued use. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM E128-99(2019) Referenced Document

2019 ASTM E128-99(2019) Standard Test Method for Maximum Pore Diameter and Permeability of Rigid Porous Filters for Laboratory Use
1999 ASTM E128-99(2011) Standard Test Method for Maximum Pore Diameter and Permeability of Rigid Porous Filters for Laboratory Use
2005 ASTM E128-99(2005) Standard Test Method for Maximum Pore Diameter and Permeability of Rigid Porous Filters for Laboratory Use
1999 ASTM E128-99 Standard Test Method for Maximum Pore Diameter and Permeability of Rigid Porous Filters for Laboratory Use