ASTM E1981-22 PDF

Scope: 1.1 This guide covers suggested procedures for the operation of a calorimetric device designed to obtain temperature and pressure data as a function of time for systems undergoing a physicochemical change under nearly adiabatic conditions. 1.2 This guide outlines the calculation of thermodynamic parameters from the time, temperature, and pressure data recorded by a calorimetric device. 1.3 The assessment outlined in this guide may be used over a pressure range from full vacuum to the rated pressure of the reaction container and pressure transducer. The temperature range of the calorimeter typically varies from ambient to 500 °C, but also may be user specified (see 6.6). 1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific safety precautions are outlined in Section 7. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM E1981-22 Referenced Document

ASTM E1231 Standard Practice for Calculation of Hazard Potential Figures-of-Merit for Thermally Unstable Materials
ASTM E476 Standard Test Method for Thermal Instability of Confined Condensed Phase Systems (Confinement Test)
ASTM E487 Standard Test Method for Constant-Temperature Stability Of Chemical Materials
ASTM E537 Standard Test Method for Assessing the Thermal Stability of Chemicals By Methods of Thermal Analysis
ASTM E680 Standard Test Method for Drop Weight Impact Sensitivity of Solid-Phase Hazardous Materials
ASTM E698 Standard Test Method for Arrhenius Kinetic Constants for Thermally Unstable Materials

2022 ASTM E1981-22 Standard Guide for Assessing Thermal Stability of Materials by Methods of Accelerating Rate Calorimetry
2020 ASTM E1981-98(2020) Standard Guide for Assessing Thermal Stability of Materials by Methods of Accelerating Rate Calorimetry
1998 ASTM E1981-98(2012)e2 Standard Guide for Assessing Thermal Stability of Materials by Methods of Accelerating Rate Calorimetry
1998 ASTM E1981-98(2012)e1 Standard Guide for Assessing Thermal Stability of Materials by Methods of Accelerating Rate Calorimetry
1998 ASTM E1981-98(2004) Standard Guide for Assessing the Thermal Stability of Materials by Methods of Accelerating Rate Calorimetry
1998 ASTM E1981-98 Standard Guide for Assessing the Thermal Stability of Materials by Methods of Accelerating Rate Calorimetry