ASTM F2582-20 PDF

Scope: 1.1 This test method covers a procedure to simulate dynamic impingement between femoral and acetabular components in a hip replacement; the subsequent qualitative assessment of damage modes (as outlined in 8.2); and, if necessary, quantitative assessment of changes in modular component attachment strength. 1.2 This test method can be used to evaluate impingement between femoral components and the following: single-piece, modular, semi-constrained, bipolar, constrained, or dual mobility acetabular components, manufactured from polymeric, metallic, or ceramic materials. 1.3 The values stated in SI units are regarded as the standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM F2582-20 Referenced Document

ASTM E4 Standard Practices for Force Verification of Testing Machines
ASTM F1820 Standard Test Method for Determining the Axial Disassembly Force of a Modular Acetabular Device
ASTM F2003 Standard Practice for Accelerated Aging of Ultra-High Molecular Weight Polyethylene After Gamma Irradiation in Air*， 2022-11-15 Update
ASTM F2009 Standard Test Method for Determining the Axial Disassembly Force of Taper Connections of Modular Prostheses
ASTM F2033 Standard Specification for Total Hip Joint Prosthesis and Hip Endoprosthesis Bearing Surfaces Made of Metallic, Ceramic, and Polymeric Materials
ASTM F2091 Standard Specification for Acetabular Prostheses*， 2024-04-22 Update
ISO 14242-1 Implants for surgery — Wear of total hip-joint prostheses — Part 1: Loading and displacement parameters for wear-testing machines and corresponding environmental conditions for test AMENDMENT 1
ISO 21535 Non-active surgical implants — Joint replacement implants — Specific requirements for hip-joint replacement implants*， 2023-06-01 Update
ISO 7206-1 Implants for surgery - Partial and total hip joint prostheses - Part 1: Classification and designation of dimensions
ISO 7206-6 Implants for surgery.Partial and total hip joint prostheses.Part 6: Endurance properties testing and performance requirements of neck region of stemmed femoral components

2020 ASTM F2582-20 Standard Test Method for Dynamic Impingement Between Femoral and Acetabular Hip Components
2014 ASTM F2582-14 Standard Test Method for Impingement of Acetabular Prostheses
2008 ASTM F2582-08 Standard Test Method for Impingement of Acetabular Prostheses