This International Standard specifies a method for the determination of the density of natural rubber latex concentrate between the temperatures of 5 ℃ and 40 ℃. The standard is intended for use when density determinations are used to calculate the mass of a measured volume of latex in locations where it is not practical to weigh directly or to control the tempera-ture of the laboratory. For such purposes, it is essen-tial that the density be determined on a latex sample containing the same amount of air as it contained when the volume was measured. Therefore, the latex bulk is allowed to stand for a minimum period of 24 h before sampling to ensure the removal of air bubbles. The density determination is preferably made at the same temperature as the volume measurement, otherwise a correction must be ap-plied.
This method is suitable for all latices from natural sources, for synthetic latex and for compounded or prevulcanized latex, as well as for artificial dispersions of rubber; however, the temperature correction given in 7.2 is not necessarily valid for all these.
For measurements made at standard temperatures, ISO 8962:1987, Plastics —Polymer dispersions —Determination of density should be used.
NOTE 1 It is intended that future editions of ISO 8962 will be modified to include latex in the scope.
BS 6057-3.7:1995 history
2015BS ISO 705:2015 Rubber latex. Determination of density between 5 C and 40 C
1995BS 6057-3.7:1995 Rubber latices - Methods of test - Determination of density of natural rubber latices
1982BS 6057 Pt.3 Sec.3.7:1982 Rubber latices. Methods of test. Determination of density of natural rubber latices