ASTM D1155-10(2020)
Standard Test Method for Roundness of Glass Spheres

Standard No.
ASTM D1155-10(2020)
Release Date
2020
Published By
American Society for Testing and Materials (ASTM)
Latest
ASTM D1155-10(2020)
Scope
1.1 This test method2 covers the determination of the percent of true spheres in glass spheres used for retroreflective marking purposes and industrial uses. 1.2 This test method includes two procedures as follows: 1.2.1 Procedure A, in which the selected specimen is split into two size ranges or groups prior to separation into true spheres and irregular particles, and 1.2.2 Procedure B, in which the selected specimen is split into five size ranges or groups prior to separation. 1.2.3 In determining compliance with specification requirements, either Procedure A or Procedure B may be used. Where tests indicate failure to meet the specified percent of true spheres and irregular particles, the referee test shall be made in accordance with Procedure B. 1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D1155-10(2020) Referenced Document

  • ASTM E11 Standard Specification for Wire Cloth and Sieves for Testing Purposes
  • ASTM E177 Standard Practice for Use of the Terms Precision and Bias in ASTM Test Methods
  • ASTM E691 Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method

ASTM D1155-10(2020) history

Standard Test Method for Roundness of Glass Spheres


Copyright ©2024 All Rights Reserved