ASTM A915/A915M-08(2018) PDF

Scope: 1.1 This specification covers carbon and low-alloy steel castings having chemical analyses similar to those of the standard wrought grades. 1.2 Several grades are covered and are designated by chemical composition shown in Table 1. 1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. 1.3.1 Within the text, the SI units are shown in brackets. 1.3.2 Inch-pound units are applicable for material ordered to Specification A915, and SI units for material ordered to Specification A915M. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM A915/A915M-08(2018) Referenced Document

ASTM A370 Standard Test Methods and Definitions for Mechanical Testing of Steel Products
ASTM A781/A781M Standard Specification for Castings, Steel and Alloy, Common Requirements, for General Industrial Use*， 2021-05-01 Update

2018 ASTM A915/A915M-08(2018) Standard Specification for Steel Castings, Carbon, and Alloy, Chemical Requirements Similar to Standard Wrought Grades
2008 ASTM A915/A915M-08(2013) Standard Specification for Steel Castings, Carbon, and Alloy, Chemical Requirements Similar to Standard Wrought Grades
2008 ASTM A915/A915M-08 Standard Specification for Steel Castings, Carbon, and Alloy, Chemical Requirements Similar to Standard Wrought Grades
1993 ASTM A915/A915M-93(2003) Standard Specification for Steel Castings, Carbon, and Alloy, Chemical Requirements Similar to Standard Wrought Grades
1998 ASTM A915/A915M-93(1998) Standard Specification for Steel Castings, Carbon, and Alloy, Chemical Requirements Similar to Standard Wrought Grades