ASTM D7056-07(2018)
Standard Test Method for Determining the Tensile Shear Strength of Prefabricated Bituminous Geomembrane Seams

Standard No.

ASTM D7056-07(2018)

Release Date

2018

Published By

American Society for Testing and Materials (ASTM)

Latest

ASTM D7056-07(2018)

Scope

1.1 This test method presents the procedures used for determining the quality of prefabricated bituminous geomembrane (PBGM) bonded seams subjected to a shear test. It describes a destructive quality control test used to determine the integrity of PBGM seams. 1.2 This test procedure is intended for PBGMs only. 1.3 The type of thermal field seaming technique used to construct PBGM seams include the following. 1.3.1 Torch-On—This technique melts two PBGM surfaces to be seamed by running a flame from a propane torch between them. Pressure is applied on the top or bottom, or both PBGMs, forcing together both surfaces to form a continuous bond. 1.3.2 Hot Air—This technique introduces high-temperature air or gas between two PBGM surfaces to facilitate melting. Pressure is applied on the top or bottom, or both PBGMs, forcing together both surfaces to form a continuous bond. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D7056-07(2018) Referenced Document

• ASTM D5199 Standard Test Method for Measuring the Nominal Thickness of Geosynthetics*， 2024-04-22 Update
• ASTM D638 Standard Test Method for Tensile Properties of Plastics
• ASTM E691 Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method

ASTM D7056-07(2018) history

• 2018 ASTM D7056-07(2018) Standard Test Method for Determining the Tensile Shear Strength of Prefabricated Bituminous Geomembrane Seams
• 2007 ASTM D7056-07(2012) Standard Test Method for Determining the Tensile Shear Strength of Pre-Fabricated Bituminous Geomembrane Seams
• 2007 ASTM D7056-07 Standard Test Method for Determining the Tensile Shear Strength of Pre-Fabricated Bituminous Geomembrane Seams
• 2004 ASTM D7056-04 Standard Test Method for Determining the Tensile Shear Strength of Pre-Fabricated Bituminous Geomembrane Seams