ASTM D1596-14(2021)
Standard Test Method for Dynamic Shock Cushioning Characteristics of Packaging Material
- Standard No.
- ASTM D1596-14(2021)
- Release Date
- 2021
- Published By
- American Society for Testing and Materials (ASTM)
- Status
- Replace By
- ASTM D1596-14(2023)
- Latest
- ASTM D1596-14(2023)
- Scope
- 1.1 This test method covers a procedure for obtaining dynamic shock cushioning characteristics of packaging materials through acceleration-time data achieved from dropping a falling guided platen assembly onto a motionless sample. This test method does not address any effects or contributions of exterior packaging assemblies. 1.2 The data acquired may be used for a single point or for use in developing a dynamic cushion curve for the specific material being tested. Such data may be used for comparison among different materials at specific input conditions, or qualifying materials against performance specifications. Caution should be used when attempting to compare data from different methods or when using such data for predicting in-package performance. Depending upon the particular materials of concern, correlation of such data (from among differing procedures or for predicting in–package performance) may be highly variable. NOTE 1—Alternative and related method for possible consideration is Test Method D4168. 1.3 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM D1596-14(2021) Referenced Document
- ASTM D4168 Standard Test Methods for Transmitted Shock Characteristics of Foam-in-Place Cushioning Materials
- ASTM D4332 Standard Practice for Conditioning Containers, Packages, or Packaging Components for Testing
- ASTM D996 Standard Terminology of Packaging and Distribution Environments
- ASTM E105 Standard Practice for Probability Sampling Of Materials*， 2024-04-22 Update
- ASTM E122 Standard Practice for Calculating Sample Size to Estimate, With a Specified Tolerable Error, the Average for Characteristic of a Lot or Process
ASTM D1596-14(2021) history
- 2023 ASTM D1596-14(2023) Standard Test Method for Dynamic Shock Cushioning Characteristics of Packaging Material
- 2021 ASTM D1596-14(2021) Standard Test Method for Dynamic Shock Cushioning Characteristics of Packaging Material
- 2014 ASTM D1596-14 Standard Test Method for Dynamic Shock Cushioning Characteristics of Packaging Material
- 1997 ASTM D1596-97(2011) Standard Test Method for Dynamic Shock Cushioning Characteristics of Packaging Material
- 1997 ASTM D1596-97(2003) Standard Test Method for Dynamic Shock Cushioning Characteristics of Packaging Material
- 1997 ASTM D1596-97 Standard Test Method for Dynamic Shock Cushioning Characteristics of Packaging Material
