1.1 This specification covers mineral-colloid-stabilized, emulsified refined coal tar suitable for use as a weatherprotective and petroleum (aliphatic) solvent resistant coating. This product is typically applied to commercial lots and other low speed bituminous concrete pavements suitable for protection.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM D6945/D6945M-03(2017) Referenced Document
ASTM C136/C136M Standard Test Method for Sieve Analysis of Fine and Coarse Aggregates*, 2019-12-01 Update
ASTM C142/C142M Standard Test Method for Clay Lumps and Friable Particles in Aggregates*, 2023-10-01 Update
ASTM D140/D140M Standard Practice for Sampling Asphalt Materials*, 2023-12-01 Update
ASTM D2939 Standard Test Methods for Emulsified Bitumens Used as Protective Coatings
ASTM D3423/D3423M Standard Practice for Application of Emulsified Coal-Tar Pitch (Mineral Colloid Type)