ASTM D6919-17
Standard Test Method for Determination of Dissolved Alkali and Alkaline Earth Cations and Ammonium in Water and Wastewater by Ion Chromatography

Standard No.

ASTM D6919-17

Release Date

2017

Published By

American Society for Testing and Materials (ASTM)

Latest

ASTM D6919-17

Scope

1.1 This test method is valid for the simultaneous determination of the inorganic alkali and alkaline earth cations, lithium, sodium, potassium, magnesium, and calcium, as well as the ammonium cation in reagent water, drinking water, and wastewaters by suppressed and nonsuppressed ion chromatography. 1.2 The anticipated range of the test method is 0.05–200 mg/L. The specific concentration ranges tested for this test method for each cation were as follows (measured in mg/L): Lithium 0.4–10.0 Sodium 4.0–40.0 Ammonium 0.4–10.0 Potassium 1.2–20.0 Magnesium 2.4–20.0 Calcium 4.0–40.0 1.2.1 The upper limits may be extended by appropriate dilution or by the use of a smaller injection volume. In some cases, using a larger injection loop may extend the lower limits. It is the responsibility of the user to ensure the validity of this test method for concentrations if the range is extended. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 It is the user’s responsibility to ensure the validity of these test methods for waters of untested matrices. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For hazards statements specific to this test method, see 8.3. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D6919-17 Referenced Document

• ASTM D1129 Standard Terminology Relating to Water
• ASTM D1193 Standard Specification for Reagent Water
• ASTM D2777 Standard Practice for Determination of Precision and Bias of Applicable Methods of Committee D-19 on Water
• ASTM D3370 Standard Practices for Sampling Water from Closed Conduits
• ASTM D3856 Standard Guide for Good Laboratory Practices in Laboratories Engaged in Sampling and Analysis of Water
• ASTM D4210 Standard Practice for Intralaboratory Quality Control Procedures and a Discussion on Reporting Low-Level Data
• ASTM D5810 Standard Guide for Spiking into Aqueous Samples *， 2021-07-01 Update
• ASTM D5847 Standard Practice for Writing Quality Control Specifications for Standard Test Methods for Water Analysis
• ASTM D5905 Standard Practice for the Preparation of Substitute Wastewater

ASTM D6919-17 history

• 2017 ASTM D6919-17 Standard Test Method for Determination of Dissolved Alkali and Alkaline Earth Cations and Ammonium in Water and Wastewater by Ion Chromatography
• 2009 ASTM D6919-09 Standard Test Method for Determination of Dissolved Alkali and Alkaline Earth Cations and Ammonium in Water and Wastewater by Ion Chromatography
• 2003 ASTM D6919-03 Standard Test Method for Determination of Dissolved Alkali and Alkaline Earth Cations and Ammonium in Water and Wastewater by Ion Chromatography