ASTM D5404/D5404M-12(2017)
Standard Practice for Recovery of Asphalt from Solution Using the Rotary Evaporator

Standard No.
ASTM D5404/D5404M-12(2017)
Release Date
2017
Published By
American Society for Testing and Materials (ASTM)
Status
Replace By
ASTM D5404/D5404M-21
Latest
ASTM D5404/D5404M-21
Scope
1.1 This practice is intended to recover asphalt from a solvent using the rotary evaporator to ensure that changes in the asphalt properties during the recovery process are minimized. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. 1.2.1 Residual pressure measurements are shown in both the SI unit of kPa and the commonly used non-standard equivalent unit of “mm of Hg.” 1.2.2 Measurements of volume and mass are only given in SI units because they are the only units typically used in practice when performing this standard practice. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D5404/D5404M-12(2017) Referenced Document

  • ASTM D1856 Standard Test Method for Recovery of Asphalt From Solution by Abson Method
  • ASTM D2939 Standard Test Methods for Emulsified Bitumens Used as Protective Coatings
  • ASTM D3666 Standard Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials*2024-04-22 Update
  • ASTM D6368 Standard Specification for Vapor-Degreasing Solvents Based on normal-Propyl Bromide and Technical Grade normal-Propyl Bromide*2023-08-01 Update
  • ASTM D92 Standard Test Method for Flash and Fire Points by Cleveland Open Cup

ASTM D5404/D5404M-12(2017) history

  • 2021 ASTM D5404/D5404M-21 Standard Practice for Recovery of Asphalt Binder from Solution Using the Rotary Evaporator
  • 2017 ASTM D5404/D5404M-12(2017) Standard Practice for Recovery of Asphalt from Solution Using the Rotary Evaporator
  • 2012 ASTM D5404/D5404M-12 Standard Practice for Recovery of Asphalt from Solution Using the Rotary Evaporator
  • 2011 ASTM D5404/D5404M-11 Standard Practice for Recovery of Asphalt from Solution Using the Rotary Evaporator
  • 2003 ASTM D5404-03 Standard Practice for Recovery of Asphalt from Solution Using the Rotary Evaporator
  • 2002 ASTM D5404-02 Standard Practice for Recovery of Asphalt from Solution Using the Rotary Evaporator
  • 1997 ASTM D5404-97 Standard Practice for Recovery of Asphalt from Solution Using the Rotary Evaporator
Standard Practice for Recovery of Asphalt from Solution Using the Rotary Evaporator



Copyright ©2024 All Rights Reserved