1.1 This specification2 covers manganese-vanadium-nickel alloy steel plates intended primarily for welded layered pressure vessels.
1.2 Plates under this specification are available in two grades having different strength levels as follows: Grade Tensile Strength, ksi [MPa] C 105–135 [725–930] D 3 in. [75 mm] and under 80–105 [550–725] Over 3 in. [75 mm] 75–100 [515–690]
1.3 The maximum thickness of plates is limited only by the capacity of the chemical composition to meet the specified mechanical property requirements.
1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM A225/A225M-17(2022) Referenced Document
ASTM A20/A20M Standard Specification for General Requirements for Steel Plates for Pressure Vessels
ASTM A435/A435M Standard Specification for Straight-Beam Ultrasonic Examination of Steel Plates
ASTM A577/A577M Standard Specification for Ultrasonic Angle-Beam Examination of Steel Plates
ASTM A578/A578M Standard Specification for Straight-Beam Ultrasonic Examination of Plain and Clad Steel Plates for Special Applications
ASTM A225/A225M-17(2022) history
2022ASTM A225/A225M-17(2022) Standard Specification for Pressure Vessel Plates, Alloy Steel, Manganese-Vanadium-Nickel
2017ASTM A225/A225M-17 Standard Specification for Pressure Vessel Plates, Alloy Steel, Manganese-Vanadium-Nickel
2012ASTM A225/A225M-12 Standard Specification for Pressure Vessel Plates, Alloy Steel, Manganese-Vanadium-Nickel
2003ASTM A225/A225M-03(2007) Standard Specification for Pressure Vessel Plates, Alloy Steel, Manganese-Vanadium-Nickel
2003ASTM A225/A225M-03 Standard Specification for Pressure Vessel Plates, Alloy Steel, Manganese-Vanadium-Nickel
1993ASTM A225/A225M-93(1999) Standard Specification for Pressure Vessel Plates, Alloy Steel, Manganese-Vanadium-Nickel