ASTM A632-19 PDF

Scope: 1.1 This specification covers grades of stainless steel tubing in sizes under 1⁄2 down to 0.050 in. (12.7 to 1.27 mm) in outside diameter and wall thicknesses less than 0.065 in. down to 0.005 in. (1.65 to 0.13 mm) for general corrosion-resisting and lowor high-temperature service, as designated in Table 1. NOTE 1—The grades of austenitic stainless steel tubing furnished in accordance with this specification have been found suitable for lowtemperature service down to −325°F (−200°C) in which Charpy notchedbar impact values of 15 ft·lbf (20 J), minimum, are required and these grades need not be impact tested. 1.2 Optional supplementary requirements are provided and, when desired, shall be so stated in the order. 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM A632-19 Referenced Document

ASTM A1016/A1016M Standard Specification for General Requirements for Ferritic Alloy Steel, Austenitic Alloy Steel, and Stainless Steel Tubes
ASTM A262 Standard Practices for Detecting Susceptibility to Intergranular Attack in Austenitic Stainless Steels
ASTM A380/A380M Standard Practice for Cleaning, Descaling, and Passivation of Stainless Steel Parts, Equipment, and Systems
ASTM E165/E165M Standard Practice for Liquid Penetrant Testing for General Industry
ASTM E527 Standard Practice for Numbering Metals and Alloys (UNS)
SAE J1086 Numbering Metals and Alloys

2019 ASTM A632-19 Standard Specification for Seamless and Welded Austenitic Stainless Steel Tubing (Small-Diameter) for General Service
2004 ASTM A632-04(2014) Standard Specification for Seamless and Welded Austenitic Stainless Steel Tubing &40;Small-Diameter&41; for General Service
2004 ASTM A632-04(2009) Standard Specification for Seamless and Welded Austenitic Stainless Steel Tubing (Small-Diameter) for General Service
2004 ASTM A632-04 Standard Specification for Seamless and Welded Austenitic Stainless Steel Tubing (Small-Diameter) for General Service
2002 ASTM A632-02a Standard Specification for Seamless and Welded Austenitic Stainless Steel Tubing (Small-Diameter) for General Service
2002 ASTM A632-02 Standard Specification for Seamless and Welded Austenitic Stainless Steel Tubing (Small-Diameter) for General Service
2001 ASTM A632-01 Standard Specification for Seamless and Welded Austenitic Stainless Steel Tubing (Small-Diameter) for General Service
1998 ASTM A632-98 Standard Specification for Seamless and Welded Austenitic Stainless Steel Tubing (Small-Diameter) for General Service