ASTM D3929-03(2023) PDF

Scope: 1.1 This test method describes a procedure for determining the compatibility of adhesives with plastics based on whether the adhesive causes cracking of stressed samples. 1.2 Specimen configurations and test fixture designs are given. 1.3 This test method is suitable for products in the form of sheet or strip. It can also be used on injection molded tensile specimens or flexural bars. 1.4 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D3929-03(2023) Referenced Document

ASTM D638 Standard Test Method for Tensile Properties of Plastics
ASTM D790 Standard Test Methods for Flexural Properties of Unreinforced and Reinforced Plastics and Electrical Insulating Materials*， 2024-04-22 Update
ASTM D907 Standard Terminology of Adhesives

2023 ASTM D3929-03(2023) Standard Test Method for Evaluating Stress Cracking of Plastics by Adhesives Using the Bent-Beam Method
2003 ASTM D3929-03(2015) Standard Test Method for Evaluating Stress Cracking of Plastics by Adhesives Using the Bent-Beam Method
2003 ASTM D3929-03(2010)e1 Standard Test Method for Evaluating Stress Cracking of Plastics by Adhesives Using the Bent-Beam Method
2003 ASTM D3929-03 Standard Test Method for Evaluating Stress Cracking of Plastics by Adhesives Using the Bent-Beam Method
1996 ASTM D3929-96e1 Standard Test Method for Evaluating Stress Cracking of Plastics by Adhesives Using the Bent-Beam Method