ASTM D7049-17
Standard Test Method for Metalworking Fluid Aerosol in Workplace Atmospheres

Standard No.
ASTM D7049-17
Release Date
2017
Published By
American Society for Testing and Materials (ASTM)
Status
Replace By
ASTM D7049-24
Latest
ASTM D7049-24
Scope
1.1 This test method covers a procedure for the determination of both total collected particulate matter and extractable mass metalworking fluid aerosol concentrations in the range of 0.07 to 5 mg/m3 in workplace atmospheres. 1.2 This test method describes a standardized means of collecting worker exposure information that can be compared to existing exposure databases, using a test method that is also more specific to metal removal fluids. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D7049-17 Referenced Document

  • ASTM D1356 Standard Terminology Relating to Sampling and Analysis of Atmospheres*2024-04-21 Update
  • ASTM D3195 Standard Practice for Rotameter Calibration
  • ASTM D4532 Standard Test Method for Respirable Dust in Workplace Atmospheres
  • ASTM D4840 Standard Guide for Sample Chain-of-Custody Procedures*2018-08-15 Update
  • ASTM D5337 Standard Practice for Flow Rate for Calibration of Personal Sampling Pumps

ASTM D7049-17 history

  • 2024 ASTM D7049-24 Standard Test Method for Metalworking Fluid Aerosol in Workplace Atmospheres
  • 2017 ASTM D7049-17 Standard Test Method for Metalworking Fluid Aerosol in Workplace Atmospheres
  • 2004 ASTM D7049-04(2010) Standard Test Method for Metal Removal Fluid Aerosol in Workplace Atmospheres
  • 2004 ASTM D7049-04 Standard Test Method for Metal Removal Fluid Aerosol in Workplace Atmospheres
Standard Test Method for Metalworking Fluid Aerosol in Workplace Atmospheres



Copyright ©2024 All Rights Reserved