ASTM D3928-00a(2018)
Standard Test Method for Evaluation of Gloss or Sheen Uniformity

Standard No.
ASTM D3928-00a(2018)
Release Date
2018
Published By
American Society for Testing and Materials (ASTM)
Latest
ASTM D3928-00a(2018)
Scope
1.1 This test method covers the determination of the uniformity of gloss or sheen of a paint applied by brush to a test panel simulating an interior wall section. Variations in gloss or sheen that may be caused by short wet edge time, poor leveling, and pigment orientation or flotation during and after application are evaluated visually. 1.2 Because both the application and the panel evaluation are very subjective, this test method should be used only for comparative testing within one laboratory as the ratings assigned by different laboratories do not usually agree (see 8.1). 1.3 The values given in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D3928-00a(2018) history

Standard Test Method for Evaluation of Gloss or Sheen Uniformity


Copyright ©2024 All Rights Reserved