ASTM F2971-13(2021) PDF

Scope: 1.1 This practice describes a standard procedure for reporting results by testing or evaluation of specimens produced by additive manufacturing (AM). This practice provides a common format for presenting data for AM specimens, for two purposes: (1) to establish further data reporting requirements, and (2) to provide information for the design of material property databases. 1.2 The values stated in SI units are required for all additive manufacturing related standards. However, when this standard is used in combination with any test method or equipment specified in inch-pound units the results should be reported with mathematical conversions to SI units immediately following in parentheses. The conversions shall be provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM F2971-13(2021) Referenced Document

ASTM D638 Standard Test Method for Tensile Properties of Plastics
ASTM E8M Standard Test Methods for Tension Testing of Metallic Materials [Metric] *， 2024-04-21 Update
ASTM F2792 Standard Terminology for Additive Manufacturing Technologies^,*， 2024-04-21 Update
ASTM F2921 Standard Terminology for Additive Manufacturing—Coordinate Systems and Test Methodologies
ASTM F2924 Standard Specification for Additive Manufacturing Titanium-6 Aluminum-4 Vanadium with Powder Bed Fusion*， 2021-10-01 Update

2021 ASTM F2971-13(2021) Standard Practice for Reporting Data for Test Specimens Prepared by Additive Manufacturing
2013 ASTM F2971-13 Standard Practice for Reporting Data for Test Specimens Prepared by Additive Manufacturing