ASTM D3302/D3302M-22
Standard Test Method for Total Moisture in Coal

Standard No.
ASTM D3302/D3302M-22
Release Date
2022
Published By
American Society for Testing and Materials (ASTM)
Status
Replace By
ASTM D3302/D3302M-22a
Latest
ASTM D3302/D3302M-22a
Scope
1.1 This test method covers the measurement of the total moisture in coal as it exists at the site, at the time, and under the conditions it is sampled. It is applicable to coals as mined, processed, shipped, or used in normal commercial pursuits. It is not applicable to coal-water slurries, sludges, or pulverized products under 0.5 mm-diameter sieve size. It is applicable to coals of all ranks within the recognized limitations imposed by oxidation and decomposition characteristics of lower rank coals. Because of its empirical nature, strict adherence to basic principles and permissive procedures are required for valid results (see Appendix X1). This complete standard is available to producers, sellers, and consumers as a total moisture method when other procedures or modifications are not mutually agreed on. 1.2 Since coal can vary from extremely wet (watersaturated) to completely dry, special emphasis must be placed on the sampling, sample preparation, and the moisture determination itself to ensure total reliability of measurement. Therefore, this standard entails collection of the gross sample, sample preparation, and the method of determination. 1.3 While it is recognized that such a standard may be unwieldy for routine usage in commercial operations, it can provide a common base for agreement in cases of dispute or arbitration. The complete standard is referred to as the referee method. Embodied in the standard is the commercial method starting with the crushed and divided sample when the gross sample is not too wet to crush and divide. See Practice D2961/D2961M and Test Method D3173 for other moisture methods. 1.4 Units—The values stated in either SI units or inchpound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D3302/D3302M-22 Referenced Document

  • ASTM D121 Standard Terminology of Coal and Coke*， 2024-03-01 Update
  • ASTM D2013 Standard Method of Preparing Coal Samples for Analysis
  • ASTM D2234/D2234M Standard Practice for Collection of a Gross Sample of Coal
  • ASTM D2961/D2961M Standard Practice for Single-Stage Total Moisture Less than 15 % in Coal Reduced to 2.36 mm [No. 8 Sieve] Topsize
  • ASTM D3173 Standard Test Method for Moisture in the Analysis Sample of Coal and Coke
  • ASTM D388 Standard Classification of Coals by Rank
  • ASTM D5865 Standard Test Method for Gross Calorific Value of Coal and Coke
  • ASTM D7430 Standard Practice for Mechanical Sampling of Coal
  • ISO 13909-4 Hard coal and coke - Mechanical sampling - Part 4: Coal - Preparation of test samples

ASTM D3302/D3302M-22 history

Standard Test Method for Total Moisture in Coal


Copyright ©2024 All Rights Reserved