ASTM E1129/E1129M-19
Standard Specification for Thermocouple Connectors

Standard No.
ASTM E1129/E1129M-19
Release Date
2019
Published By
American Society for Testing and Materials (ASTM)
Latest
ASTM E1129/E1129M-19
Scope
1.1 This specification covers separable single-circuit thermocouple connectors with two round pins. Connectors covered by this specification must be rated for continuous use to at least 300 °F (150 °C), but they may optionally be rated to a higher temperature. 1.2 This specification does not cover multiple-circuit connectors, multi-pin connectors, miniature connectors, or connectors intended primarily for panel mounting. High temperature connectors (for example, those designed for continuous use at temperatures above approximately 500 °F (260 °C)) are not intended to be covered by this specification. 1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. The values stated in brackets are not conversions to the values they succeed and therefore shall be used independently of the preceding values. The values given in parentheses are conversions of the values they succeed. Combining values from the two systems may result in non-conformance with the standard. 1.4 The following precautionary statement pertains only to the test methods portion, Section 9, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM E1129/E1129M-19 Referenced Document

  • ASTM E220 Standard Test Method for Calibration of Thermocouples By Comparison Techniques
  • ASTM E230/E230M Standard Specification for Temperature-Electromotive Force (emf) Tables for Standardized Thermocouples*， 2023-11-01 Update
  • ASTM E2820 Standard Test Method for Evaluating Thermal EMF Properties of Base-Metal Thermocouple Connectors
  • ASTM E344 Terminology Relating to Thermometry and Hydrometry*， 2023-12-01 Update
  • ASTM E608/E608M Standard Specification for Mineral-Insulated, Metal-Sheathed Base Metal Thermocouples

ASTM E1129/E1129M-19 history

Standard Specification for Thermocouple Connectors


Copyright ©2024 All Rights Reserved