ASTM C1848-17a(2023) PDF

Scope: 1.1 This practice covers the installation of high-pressure spray polyurethane foam (SPF) as an insulation for building enclosure assemblies including: walls, ceilings, attics, floors, and crawl spaces. This practice does not apply to SPF used strictly as a component for an air barrier system or for SPF used in roofing applications. 1.2 Building design criteria and selection of SPF are beyond the scope of this practice. 1.3 The use of SPF insulation covered by this practice is typically regulated by building codes or other agencies that address fire performance. Where required the fire performance of the material shall be addressed through standard fire test methods established by the appropriate governing documents. 1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM C1848-17a(2023) Referenced Document

ASTM C168 Standard Terminology Relating to Thermal Insulation
ASTM D4263 Standard Test Method for Indicating Moisture in Concrete by the Plastic Sheet Method
ASTM D4449 Standard Test Method for Visual Evaluation of Gloss Differences Between Surfaces of Similar Appearance
ASTM D4541 Standard Test Method for Pull-Off Strength of Coatings Using Portable Adhesion Testers
ASTM D5469 Standard Guide for Application of New Spray Applied Polyurethane Foam and Coated Roofing Systems*， 2024-04-21 Update
ASTM D6226 Standard Test Method for Open Cell Content of Rigid Cellular Plastics
ASTM D7425 Standard Specification for Spray Polyurethane Foam Used for Roofing Applications*， 2024-04-21 Update
SSPC SP 1
SSPC SP 6 Commercial Blast Cleaning

2023 ASTM C1848-17a(2023) Standard Practice for Installation of High-Pressure Spray Polyurethane Foam Insulation for the Building Enclosure
2017 ASTM C1848-17a Standard Practice for Installation of High-Pressure Spray Polyurethane Foam Insulation for the Building Enclosure
2017 ASTM C1848-17 Standard Practice for Installation of High-Pressure Spray Polyurethane Foam Insulation for the Building Enclosure