1.1 This specification covers a low-density material based on poly (vinylidene fluoride) (PVDF), intended for use as jacketing material for wire and cable.
1.1.1 The material has a closed cell foam structure.
1.2 The jacketing material covered in this specification is intended for use in wires and cables in power-limited applications, such as optical fiber cables, communications cables, coaxial cables, or power limited fire alarm cables. The material is not intended for use in power cables.
1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM D8318-20 Referenced Document
ASTM D149 Standard Test Method for Dielectric Breakdown Voltage and Dielectric Strength of Solid Electrical Insulating Materials at Commercial Power Frequencies
ASTM D150 Standard Test Methods for AC Loss Characteristics and Permittivity (Dielectric Constant) of Solid Electrical Insulation
ASTM D1711 Standard Terminology Relating to Electrical Insulation
ASTM D2633 Standard Methods of Testing Thermoplastic Insulations and Jackets for Wire and Cable
ASTM D3222 Standard Specification for Unmodified Poly(Vinylidene Fluoride) (PVDF) Molding Extrusion and Coating Materials
ASTM D3418 Standard Test Method for Transition Temperatures of Polymers By Differential Scanning Calorimetry
ASTM D3801 Standard Test Method for Measuring the Comparative Burning Characteristics of Solid Plastics in a Vertical Position
ASTM D5575 Standard Specification for Copolymers of Vinylidene Fluoride (VDF) with Other Fluorinated Monomers
ASTM D638 Standard Test Method for Tensile Properties of Plastics
ASTM D790 Standard Test Methods for Flexural Properties of Unreinforced and Reinforced Plastics and Electrical Insulating Materials*, 2024-04-21 Update
ASTM D792 Standard Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement
ASTM E162 Standard Test Method for Surface Flammability of Materials Using a Radiant Heat Energy Source