ASTM D3288/D3288M-20 PDF

Scope: 1.1 These test methods cover testing liquid enamel coatings used to produce film-insulated magnet wire. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined 1.3 The test methods appear as follows: Sections Density 6 – 10 Determined Solids 16 – 22 Effective Solids 31 – 37 Flash Point 11 – 15 Infrared Analysis 45 – 50 Stack Loss 23 – 30 Viscosity 38 – 44 1.4 There is no known IEC equivalent document. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D3288/D3288M-20 Referenced Document

ASTM D1298 Standard Test Method for Density, Relative Density (Specific Gravity), or API Gravity of Crude Petroleum and Liquid Petroleum Products by Hydrometer Method
ASTM D1475 Standard Test Method For Density of Liquid Coatings, Inks, and Related Products
ASTM D1711 Standard Terminology Relating to Electrical Insulation
ASTM D29 Standard Specification for Centrifugally Cast "Fibreglass" (Glass Fiber Reinforced Thermosetting Resin) Pipe
ASTM D476 Standard Classification for Dry Pigmentary Titanium Dioxide Products*， 2024-04-21 Update
ASTM D5423 Standard Specification for Forced-Convection Laboratory Ovens for Evaluation of Electrical Insulation
ASTM D56 Standard Test Method for Flash Point by Tag Closed Tester
ASTM E131 Standard Definitions of Terms and Symbols Relating to Molecular Spectroscopy
ASTM E168 Standard Practices for General Techniques of Infrared Quantitative Analysis
ASTM E2975 Standard Test Method for Calibration or Calibration Verification of Concentric Cylinder Rotational Viscometers*， 2023-01-01 Update
ASTM E691 Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method