ASTM D5710/D5710M-22 PDF

Scope: 1.1 This specification covers Trinidad Lake modified asphalt for use in the construction of pavements. 1.2 This specification covers the following penetration grades: 40–55 60–75 80–100 120–150 1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D5710/D5710M-22 Referenced Document

ASTM D113 Standard Test Method for Ductility of Bituminous Materials
ASTM D140/D140M Standard Practice for Sampling Asphalt Materials*， 2023-12-01 Update
ASTM D1754/D1754M Standard Test Method for Effects of Heat and Air on Asphaltic Materials (Thin-Film Oven Test)
ASTM D1856 Standard Test Method for Recovery of Asphalt From Solution by Abson Method
ASTM D2170/D2170M Standard Test Method for Kinematic Viscosity of Asphalts*， 2022-11-01 Update
ASTM D2172/D2172M Standard Test Methods for Quantitative Extraction of Asphalt Binder from Asphalt Mixtures
ASTM D2415 Standard Test Method for Ash in Coal Tar and Pitch
ASTM D2872 Standard Test Method for Effect of Heat and Air on a Moving Film of Asphalt (Rolling Thin-Film Oven Test)
ASTM D5/D5M Standard Test Method for Penetration of Bituminous Materials
ASTM D7553 Standard Test Method for Solubility of Asphalt Materials in N-Propyl Bromide*， 2024-04-21 Update
ASTM D92 Standard Test Method for Flash and Fire Points by Cleveland Open Cup

2022 ASTM D5710/D5710M-22 Standard Specification for Trinidad Lake Modified Asphalt
2021 ASTM D5710/D5710M-21 Standard Specification for Trinidad Lake Modified Asphalt
2015 ASTM D5710/D5710M-15 Standard Specification for Trinidad Lake Modified Asphalt
2013 ASTM D5710/D5710M-13 Standard Specification for Trinidad Lake Modified Asphalt
2005 ASTM D5710-05 Standard Specification for Trinidad Lake Modified Asphalt
2003 ASTM D5710-03 Standard Specification for Trinidad Lake Modified Asphalt
1995 ASTM D5710-95(2001) Standard Specification for Trinidad Lake Modified Asphalt
1995 ASTM D5710-95 Standard Specification for Trinidad Lake Modified Asphalt