This technical information report specifies a guideline for the hardware requirements for fueling a Hydrogen Surface Vehicle (HSV) with compressed hydrogen storage rated at a Nominal Working Pressure of 70 MPa. It contains a description of the receptacle geometry and optional communication hardware and communications protocol to refuel the HSV. The intent of this document is to enable harmonized development and implementation of the hydrogen fueling interfaces. It is intended to be utilized for hydrogen vehicle field evaluations until enough information is collected to enable standardization. The receptacle portion of this document is to be reevaluated utilizing international field data in approximately two (2) years and subsequently superseded by SAE J2600 in the 2009 timeframe. At that time@ input would be gathered from international locations through representation in the SAE Fuel Cell Standards Committee in order to arrive at a final decision regarding the direction of the receptacle and communications standard. The communications portion of this document is also to be reevaluated utilizing international field data and subsequently superseded by SAE J2601. It is anticipated that the communications protocol and hardware could be standardized before the above mentioned timeframe. It is not the intent of this document to imply a position regarding the commercial fueling protocol@ communication@ or noncommunication strategy@ but simply serves as a reference for the receptacle hardware and IRDA communications if this strategy is selected. In addition@ it is not intended be referenced by other Standard and/or Code organizations. Gaseous Hydrogen Fueling System Overview The overall hydrogen fueling system consists of a dispenser and HSV. The connector couples the hydrogen fueling system (dispenser) and the HSV@ and that hydrogen fueling coupling is specified as the fueling connector interface. There are three portions of the hydrogen fueling coupling: a mechanical portion@ a process portion@ and a data portion. This document describes the mechanical and data portions of the fueling interface. See Figure 1.
SAE J2799-2007 history
2019SAE J2799-2019 70 MPa Compressed Hydrogen Surface Vehicle Fueling Connection Device and Optional Vehicle to Station Communications
2014SAE J2799-2014 Hydrogen Surface Vehicle to Station Communications Hardware and Software
2007SAE J2799-2007 70 MPa Compressed Hydrogen Surface Vehicle Fueling Connection Device and Optional Vehicle to Station Communications