ASTM D2094-00(2023) PDF

Scope: 1.1 This practice describes barand rod-type butt-joined adhesion test specimens and procedures for preparing and bonding them. The specimens are intended to be used with various adherend materials in like or unlike combinations for determining the strength properties of adhesives in accordance with Test Method D2095. 1.2 The values stated in SI units are considered to be the standard. The values in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D2094-00(2023) Referenced Document

ASTM D2093 Standard Practice for Preparation of Surfaces of Plastics Prior to Adhesive Bonding
ASTM D2095 Standard Test Method for Tensile Strength of Adhesives by Means of Bar and Rod Specimens
ASTM D2651 Standard Guide for Preparation of Metal Surfaces for Adhesive Bonding
ASTM D907 Standard Terminology of Adhesives*， 2023-05-16 Update

2023 ASTM D2094-00(2023) Standard Practice for Preparation of Bar and Rod Specimens for Adhesion Tests
2000 ASTM D2094-00(2014) Standard Practice for Preparation of Bar and Rod Specimens for Adhesion Tests
2000 ASTM D2094-00(2006) Standard Practice for Preparation of Bar and Rod Specimens for Adhesion Tests
2000 ASTM D2094-00e1 Standard Practice for Preparation of Bar and Rod Specimens for Adhesion Tests
2000 ASTM D2094-00 Standard Practice for Preparation of Bar and Rod Specimens for Adhesion Tests