1.1 This specification establishes allowable limits for the various types of surface discontinuities that may occur during the manufacture and processing of metric-series nuts with nominal diameters 5 mm and larger and inch-series nuts with nominal diameters 1/4 in. and larger. 1.2 The values stated in either SI (metric) or inch-pound units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. 1.3 When the engineering requirements of the application necessitate control of surface discontinuities on nuts, the purchaser shall specify conformance to this ASTM specification in the original inquiry and purchase order. 1.3.1 When the engineering requirements of the application necessitate that surface discontinuities on nuts be controlled within limits closer than those specified in this specification, the purchaser shall specify the applicable limits in the original inquiry and purchase order. 1.4 The allowable limits established in this specification for metric nuts, with nominal diameters 5 to 24 mm inclusive, are essentially identical with requirements given in ISO/DIS 6157/II. There are no ISO standards for surface discontinuities on metric-series nuts with nominal diameters larger than 24 mm or on any inch-series nuts. 1.5 The following precautionary caveat pertains only to the test method portion, Section 7 , of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM F812/F812M-12(2022)e1 history
2023ASTM F812/F812M-12(2022)e1 Standard Specification for Surface Discontinuities of Nuts, Inch and Metric Series
2022ASTM F812-12(2022) Standard Specification for Surface Discontinuities of Nuts, Inch and Metric Series
2017ASTM F812-12(2017) Standard Specification for Surface Discontinuities of Nuts, Inch and Metric Series
2012ASTM F812-12 Standard Specification for Surface Discontinuities of Nuts, Inch and Metric Series
2007ASTM F812/F812M-07 Standard Specification for Surface Discontinuities of Nuts, Inch and Metric Series
2003ASTM F812/F812M-03 Standard Specification for Surface Discontinuities of Nuts, Inch and Metric Series
2002ASTM F812/F812M-02 Standard Specification for Surface Discontinuities of Nuts, Inch and Metric Series
1997ASTM F812/F812M-97 Standard Specification for Surface Discontinuities of Nuts, Inch and Metric Series