ASTM D4880-18 PDF

Scope: 1.1 This test method covers the electrical performance in a specified water solution of an insulating varnish applied over enamelled magnet wire. 1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 6. NOTE 1—There is no IEC method equivalent to this standard. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D4880-18 Referenced Document

2018 ASTM D4880-18 Standard Test Method for Salt Water Proofness of Insulating Varnishes Over Enamelled Magnet Wire
2014 ASTM D4880-14 Standard Test Method for Salt Water Proofness of Insulating Varnishes Over Enamelled Magnet Wire
2008 ASTM D4880-08 Standard Test Method for Salt Water Proofness of Insulating Varnishes Over Enamelled Magnet Wire
2003 ASTM D4880-03 Standard Test Method for Salt Water Proofness of Insulating Varnishes Over Enamelled Magnet Wire
1994 ASTM D4880-94(1998) Standard Test Method for Salt Water Proofness of Insulating Varnishes Over Enamelled Magnet Wire