ASTM D4536-96
Standard Test Method for High-Volume Sampling for Solid Particulate Matter and Determination of Particulate Emissions

Standard No.
ASTM D4536-96
Release Date
1996
Published By
American Society for Testing and Materials (ASTM)
Status
 2000-01
Latest
ASTM D4536-96
Scope
1.1 This test method can be used to estimate the particulate matter concentration in stationary source stacks. 1.2 With the nozzle sizes specified herein, the method can be used for stack stream velocities from approximately 4 to 45 m/s (800 to 8 000 ft/min). 1.3 Particulate matter present in a gaseous phase at the filtration temperature will not be collected. If significant quantities of condensible particulate matter are expected, this test method may not be the method of choice. If the temperature of the sampled gas at the filter is below the stream dewpoint this test method will not work. If moisture is expected to condense between the filter and the orifice, this test method is not applicable unless a moisture collection device is placed immediately upstream of the orifice and the sampling rate is adjusted for the volume of gas that condensed upstream of the orifice. 1.4 The values stated in SI units are to be regarded as the standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM D4536-96 Referenced Document

  • ASTM D1071 Standard Test Methods for Volumetric Measurement of Gaseous Fuel Samples
  • ASTM D1356 Standard Terminology Relating to Sampling and Analysis of Atmospheres*2024-04-21 Update
  • ASTM D2986 Standard Practice for Evaluation of Air Assay Media by the Monodisperse DOP (Dioctyl Phthalate) Smoke Test (Withdrawn 2004)*2017-08-16 Update
  • ASTM D3154 Standard Test Method for Average Velocity in a Duct (Pitot Tube Method)*2023-01-01 Update
  • ASTM D3464 Standard Test Method for Average Velocity in a Duct Using a Thermal Anemometer*2023-01-01 Update
  • ASTM E1 Standard Specification for ASTM Thermometers*1998-04-21 Update

ASTM D4536-96 history

  • 1996 ASTM D4536-96 Standard Test Method for High-Volume Sampling for Solid Particulate Matter and Determination of Particulate Emissions
Standard Test Method for High-Volume Sampling for Solid Particulate Matter and Determination of Particulate Emissions



Copyright ©2024 All Rights Reserved