1.1 This test method2 covers the evaluation of the galvanic and environmental corrosion interaction characteristics of dry solid film lubricants when in contact with an aluminum surface under conditions of high humidity.
1.2 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM D2649-20a Referenced Document
ASTM B209 Standard Specification for Aluminum and Aluminum- Alloy Sheet and Plate
ASTM B308/B308M Standard Specification for Aluminum-Alloy 6061-T6 Standard Structural Profiles
ASTM D1730 Standard Practices for Preparation of Aluminum and Aluminum-Alloy Surfaces for Painting
ASTM D1748 Standard Test Method for Rust Protection by Metal Preservatives in the Humidity Cabinet
ASTM D2247 Standard Practice for Testing Water Resistance of Coatings in 100% Relative Humidity
ASTM D235 Standard Specification for Mineral Spirits (Petroleum Spirits) (Hydrocarbon Dry Cleaning Solvent)