ASTM D7369-20 PDF

Scope: 1.1 This test method covers procedures for preparing and testing laboratory-fabricated or field-recovered cores of asphalt mixtures to determine resilient modulus values using a repeated-load indirect tension test. 1.2 The values stated in SI units are regarded as the standard. Values in parentheses are for informational use. 1.3 A precision and bias statement for this standard has not been developed at this time. Therefore, this standard should not be used for acceptance or rejection of a material for purchasing purposes. 1.4 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D7369-20 Referenced Document

ASTM D3666 Standard Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials*， 2024-04-21 Update
ASTM D6925 Standard Test Method for Preparation and Determination of the Relative Density of Asphalt Mix Specimens by Means of the Superpave Gyratory Compactor*， 2023-12-01 Update
ASTM D6926 Standard Practice for Preparation of Asphalt Mixture Specimens Using Marshall Apparatus
ASTM D6931 Standard Test Method for Indirect Tensile (IDT) Strength of Asphalt Mixtures
ASTM D8 Standard Terminology Relating to Materials for Roads and Pavements

2020 ASTM D7369-20 Standard Test Method for Determining the Resilient Modulus of Asphalt Mixtures by Indirect Tension Test
2011 ASTM D7369-11 Standard Test Method for Determining the Resilient Modulus of Bituminous Mixtures by Indirect Tension Test
2009 ASTM D7369-09 Standard Test Method for Determining the Resilient Modulus of Bituminous Mixtures by Indirect Tension Test