ASTM D3419-12(2019)
Standard Practice for In-Line Screw-Injection Molding Test Specimens From Thermosetting Compounds

Standard No.

ASTM D3419-12(2019)

Release Date

2019

Published By

American Society for Testing and Materials (ASTM)

Latest

ASTM D3419-12(2019)

Scope

1.1 This practice covers the general principles to be followed when injection molding test specimens of thermosetting materials. It is to be used to obtain uniformity in methods of describing the various steps of the injection molding process and in the reporting of those conditions. The exact molding conditions will vary from material to material, and if not incorporated in the material specification, shall be agreed upon between the purchaser and the supplier or determined by previous experience with the particular type of material being used and its plasticity. NOTE 1—The utility of this practice has been demonstrated for the molding of thermosetting molding compounds exhibiting lower-viscosity non-Newtonian flow. 1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This practice assumes the use of reciprocating screw injection molding machines. NOTE 2—This standard and ISO 10724 address the same subject matter, but differ in technical content. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D3419-12(2019) Referenced Document

• ASTM D3641 Standard Practice for Injection Molding Test Specimens of Thermoplastic Molding and Extrusion Materials
• ASTM D883 Standard Terminology Relating to Plastics*， 2024-02-01 Update
• ISO 10724 Plastics - Thermosetting moulding materials - Injection moulding of multipurpose test specimens
• ISO 3167 Plastics - Multipurpose test specimens

ASTM D3419-12(2019) history

• 2019 ASTM D3419-12(2019) Standard Practice for In-Line Screw-Injection Molding Test Specimens From Thermosetting Compounds
• 2012 ASTM D3419-12 Standard Practice for In-Line Screw-Injection Molding Test Specimens From Thermosetting Compounds
• 2000 ASTM D3419-00(2006) Standard Practice for In-Line Screw-Injection Molding Test Specimens From Thermosetting Compounds
• 2000 ASTM D3419-00 Standard Practice for In-Line Screw-Injection Molding Test Specimens From Thermosetting Compounds
• 1993 ASTM D3419-93 Standard Practice for In-Line Screw-Injection Molding Test Specimens From Thermosetting Compounds