1.1 This specification is intended to provide a basis for identification of strippable/removable materials used to immobilize radioactive contamination, minimize worker exposure, and facilitate subsequent decontamination or to protect uncontaminated areas against the spread of radioactive contamination.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM E3104-17(2023) Referenced Document
ASTM D4060 Standard Test Method for Abrasion Resistance of Organic Coatings by the Taber Abraser
ASTM D412 Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers8212;Tension
ASTM D4541 Standard Test Method for Pull-Off Strength of Coatings Using Portable Adhesion Testers
ASTM E2731 Standard Specification for Materials to Mitigate the Spread of Radioactive Contamination after a Radiological Dispersion Event*, 2024-04-21 Update
ASTM E3104-17(2023) history
2023ASTM E3104-17(2023) Standard Specification for Strippable and Removable Coatings to Mitigate Spread of Radioactive Contamination
2017ASTM E3104-17 Standard Specification for Strippable & Removable Coatings to Mitigate Spread of Radioactive Contamination