1.1 This test method is a laboratory procedure that determines the adhesion and cohesion performance of one-part elastomeric, solvent release sealants at high and low temperatures by the extension and compression of test specimens.
1.2 Units—The values stated in either SI units or inchpound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.3 The subcommittee with jurisdiction is not aware of any similar ISO standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For a specific precautionary statement, see Note 2.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM C1216/C1216M-23 Referenced Document
ASTM C109/C109M Standard Test Method for Compressive Strength of Hydraulic Cement Mortars (Using 2-in. or [50-mm] Cube Specimens)
ASTM C150 Standard Specification for Portland Cement
ASTM C33 Standard Specification for Concrete Aggregates
ASTM C717 Standard Terminology of Building Seals and Sealants
ASTM C1216/C1216M-23 history
2023ASTM C1216/C1216M-23 Standard Test Method for Adhesion and Cohesion of One-Part Elastomeric Solvent Release Sealants
2013ASTM C1216/C1216M-13 Standard Test Method for Adhesion and Cohesion of One-Part Elastomeric Solvent Release Sealants
2003ASTM C1216-03(2008) Standard Test Method for Adhesion and Cohesion of One-Part Elastomeric Solvent Release Sealants
2003ASTM C1216-03 Standard Test Method for Adhesion and Cohesion of One-Part Elastomeric Solvent Release Sealants
1992ASTM C1216-92(1997) Standard Test Method for Adhesion and Cohesion of One-Part Elastomeric Solvent Release Sealants