ASTM D8082-18 PDF

Scope: 1.1 This standard provides a specification for elemental impurity limits in erosion control products used for land application. Erosion control products may include but are not limited to: hydraulically-applied erosion control products, rolled erosion control products, sediment retention devices, gabions and mattresses, and articulated concrete block revetments. 1.2 Units—The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D6026, unless superseded by this specification. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D8082-18 Referenced Document

ASTM D3740 Standard Practice for Minimum Requirements for Agencies Engaged in the Testing and/or Inspection of Soil and Rock as Used in Engineering Design and Construction
ASTM D3987 Standard Test Method for Shake Extraction of Solid Waste with Water
ASTM D6026 Standard Practice for Using Significant Digits in Geotechnical Data
ASTM D653 Standard Terminology Relating to Soil, Rock, and Contained Fluids

2018 ASTM D8082-18 Standard Specification for Elemental Impurity Limits in Erosion Control Products used for Land Application