1.1 This practice is intended to assist the various technical committees in the use of uniform methods of indicating the number of digits which are to be considered significant in specification limits, for example, specified maximum values and specified minimum values. Its aim is to outline methods which should aid in clarifying the intended meaning of specification limits with which observed values or calculated test results are compared in determining conformance with specifications.
1.2 This practice is intended to be used in determining conformance with specifications when the applicable ASTM specifications or standards make direct reference to this practice.
1.3 Reference to this practice is valid only when a choice of method has been indicated, that is, either absolute method or rounding method.
1.4 The system of units for this practice is not specified. Dimensional quantities in the practice are presented only as illustrations of calculation methods. The examples are not binding on products or test methods treated.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM E29-13(2019) Referenced Document
ASTM E177 Standard Practice for Use of the Terms Precision and Bias in ASTM Test Methods
ASTM E2282 Standard Guide for Defining the Test Result of a Test Method*, 2023-11-01 Update
ASTM E456 Standard Terminology for Relating to Quality and Statistics
IEEE/ASTM SI 10 American National Standard for Metric Practice
ASTM E29-13(2019) history
2022ASTM E29-22 Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
2019ASTM E29-13(2019) Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
2013ASTM E29-13 Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
2008ASTM E29-08 Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
2006ASTM E29-06b Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
2006ASTM E29-06a Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
2006ASTM E29-06 Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
2004ASTM E29-04 Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
2002ASTM E29-02e1 Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
2002ASTM E29-02 Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
1993ASTM E29-93a(1999) Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
1993ASTM E29-93a Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
1990ASTM E29-90 Standard Practice for Using Digits in Test Data to Determine Conformance with Specifications
1980ASTM E29-67(1980)e1 Standard Test Method for Indicating Which Places Of Figures Are To Be Considered Significant In Specified Limiting Values
1967ASTM E29-67 Recommended Practice For Indicating Which Places Of Figures Are To Be Considered Significant In Specified Limiting Values