ASTM D451/D451M-17 PDF

Scope: 1.1 This test method covers the determination of the particle size distribution of granular mineral surfacing material such as crushed slate, stone, coated granules, and so forth, used on the weather surface of prepared asphalt roofing and shingles. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D451/D451M-17 Referenced Document

2022 ASTM D451/D451M-17(2022) Standard Test Method for Sieve Analysis of Granular Mineral Surfacing for Asphalt Roofing Products
2017 ASTM D451/D451M-17 Standard Test Method for Sieve Analysis of Granular Mineral Surfacing For Asphalt Roofing Products
1991 ASTM D451/D451M-91(2013)e1 Standard Test Method for Sieve Analysis of Granular Mineral Surfacing For Asphalt Roofing Products
1991 ASTM D451-91(2008) Standard Test Method for Sieve Analysis of Granular Mineral Surfacing For Asphalt Roofing Products
1991 ASTM D451-91(2002) Standard Test Method for Sieve Analysis of Granular Mineral Surfacing For Asphalt Roofing Products
1996 ASTM D451-91(1996)e1 Standard Test Method for Sieve Analysis of Granular Mineral Surfacing For Asphalt Roofing Products