ASTM D413-98(2017) PDF

Scope: 1.1 These test methods cover the determination of the adhesion strength between plies of fabric bonded with rubber or the adhesion of the rubber layer in articles made from rubber attached to other material. They are applicable only when the adhered surfaces are approximately plane or uniformly circular as in belting, hose, tire carcasses, or rubber-covered sheet metal. 1.2 When the adhered surfaces contain sharp bends, angles, or other gross irregularities that cannot be avoided in preparing test specimens, special test methods must be employed for evaluating adhesion. 1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D413-98(2017) Referenced Document

ASTM D3182 Standard Practice for Rubber-Materials, Equipment, and Procedures for Mixing Standard Compounds and Preparing Standard Vulcanized Sheets
ASTM D3183 Standard Practice for Rubber-Preparation of Pieces for Test Purposes from Products

2017 ASTM D413-98(2017) Standard Test Methods for Rubber Property—Adhesion to Flexible Substrate
1998 ASTM D413-98(2013) Standard Test Methods for Rubber Propertymdash;Adhesion to Flexible Substrate
1998 ASTM D413-98(2007) Standard Test Methods for Rubber Propertyx2014;Adhesion to Flexible Substrate
1998 ASTM D413-98(2002)e1 Standard Test Methods for Rubber Property8212;Adhesion to Flexible Substrate
1998 ASTM D413-98 Standard Test Methods for Rubber Property-Adhesion to Flexible Substrate
1993 ASTM D413-82(1993)e1 Standard Test Methods for Rubber Property-Adhesion to Flexible Substrate