1.1 This specification2 covers plate, sheet, and strip of nickel-molybdenum alloys (UNS N10001, N10665, N10675, N10629, and N10624)3 as shown in Table 1, for use in general corrosive service.
1.2 The following products are covered under this specification:
1.2.1 Sheet and Strip—Hot or cold rolled, solution annealed, and descaled unless solution anneal is performed in an atmosphere yielding a bright finish.
1.2.2 Plate—Hot or cold rolled, solution annealed, and descaled.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety, health, and environmental practices, and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM B333-03(2018) Referenced Document
ASTM B906 Standard Specification for General Requirements for Flat-Rolled Nickel and Nickel Alloys Plate, Sheet, and Strip*, 2022-07-15 Update
ASTM E112 Standard Test Methods for Determining Average Grain Size
ASTM E140 Standard Hardness Conversion Tables for Metals Relationship Among Brinell Hardness, Vickers Hardness, Rockwell Hardness, Superficial Hardness, Knoop Hardness, and Scleroscope Hardness
ASTM B333-03(2018) history
2018ASTM B333-03(2018) Standard Specification for Nickel-Molybdenum Alloy Plate, Sheet, and Strip
2003ASTM B333-03(2013) Standard Specification for Nickel-Molybdenum Alloy Plate, Sheet, and Strip
2003ASTM B333-03(2008) Standard Specification for Nickel-Molybdenum Alloy Plate, Sheet, and Strip
2003ASTM B333-03 Standard Specification for Nickel-Molybdenum Alloy Plate, Sheet, and Strip
1998ASTM B333-98 Standard Specification for Nickel-Molybdenum Alloy Plate, Sheet, and Strip