ASTM D5141-11(2018)
Standard Test Method for Determining Filtering Efficiency and Flow Rate of the Filtration Component of a Sediment Retention Device

Standard No.

ASTM D5141-11(2018)

Release Date

2018

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM D5141-23

Latest

ASTM D5141-23

Scope

1.1 This test method is used to determine the filtering efficiency and the flow rate of the filtration component of a sediment retention device, such as a silt fence, silt barrier, or inlet protector. 1.1.1 The results are shown as a percentage for filtering efficiency and cubic metres per square metre per minute (m3 /m2 /min) or gallons per square foot per minute (gal/ft2 /min) for flow rate. 1.1.2 The filtering efficiency indicates the percent of sediment removed from sediment-laden water. 1.1.3 The flow rate is the average rate of passage of the sediment-laden water through the filtration component of a sediment retention device. 1.2 This test method requires several specialized pieces of equipment, such as an integrated water sampler and an analytical balance, or a vacuum filtration system. At the client’s discretion, the test soil is either a site-specific soil or a soil that is representative of a target default gradation. 1.3 The values stated in SI units are the standard, while the inch-pound units are provided for information. The values expressed in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining values in any way. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D5141-11(2018) Referenced Document

• ASTM D123 Standard Terminology Relating to Textiles*， 2023-09-14 Update
• ASTM D4354 Standard Practice for Sampling of Geosynthetics for Testing
• ASTM D4439 Standard Terminology for Geosynthetics*， 2024-02-01 Update
• ASTM D4759 Standard Practice for Determining the Specification Conformance of Geosynthetics
• ASTM D653 Standard Terminology Relating to Soil, Rock, and Contained Fluids

ASTM D5141-11(2018) history

• 2023 ASTM D5141-23 Standard Test Method for Determining Filtering Efficiency and Flow Rate of the Filtration Component of a Sediment Retention Device
• 2018 ASTM D5141-11(2018) Standard Test Method for Determining Filtering Efficiency and Flow Rate of the Filtration Component of a Sediment Retention Device
• 2011 ASTM D5141-11 Standard Test Method for Determining Filtering Efficiency and Flow Rate of the Filtration Component of a Sediment Retention Device
• 2009 ASTM D5141-09 Standard Test Method for Determining Filtering Efficiency and Flow Rate of the Filtration Component of a Sediment Retention Device Using Site-Specific Soil
• 1996 ASTM D5141-96(2004) Standard Test Method for Determining Filtering Efficiency and Flow Rate of a Geotextile for Silt Fence Application Using Site-Specific Soil
• 1996 ASTM D5141-96(1999) Standard Test Method for Determining Filtering Efficiency and Flow Rate of a Geotextile for Silt Fence Application Using Site-Specific Soil