1.1 This specification covers bare hard-drawn round copperclad steel wire for electrical purposes (Note 1). NOTE 1—Wire ordered to this specification is not intended for redrawing. If wire is desired for this purpose, consult the manufacturer.
1.2 Four grades of wire are specified, designated as follows (Note 2): Grade 40 HS, Grade 40 EHS, Grade 30 HS, and Grade 30 EHS. NOTE 2—The grades covered by this specification correspond to the following commercial designations: Grade 40 HS, High Strength, 40 % Conductivity. Grade 40 EHS, Extra High Strength, 40 % Conductivity Grade 30 HS, High Strength, 30 % Conductivity. Grade 30 EHS, Extra High Strength, 30 % Conductivity.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM B227-15(2019) Referenced Document
ASTM B193 Standard Test Method for Resistivity of Electrical Conductor Materials
ASTM B258 Standard Specification for Standard Nominal Diameters and Cross-Sectional Areas of AWG Sizes of Solid Round Wires Used as Electrical Conductors
ASTM B227-15(2019) history
2019ASTM B227-15(2019) Standard Specification for Hard-Drawn Copper-Clad Steel Wire
2015ASTM B227-15 Standard Specification for Hard-Drawn Copper-Clad Steel Wire
2010ASTM B227-10 Standard Specification for Hard-Drawn Copper-Clad Steel Wire
2004ASTM B227-04 Standard Specification for Hard-Drawn Copper-Clad Steel Wire
2003ASTM B227-03 Standard Specification for Hard-Drawn Copper-Clad Steel Wire
2002ASTM B227-02 Standard Specification for Hard-Drawn Copper-Clad Steel Wire
1998ASTM B227-98 Standard Specification for Hard-Drawn Copper-Clad Steel Wire
1980ASTM B227-70(1980) Standard Specification for Hard-Drawn Copper-Clad Steel Wire