ASTM D7575-11(2017) PDF

Scope: 1.1 This test method covers the determination of oil and grease in produced and waste water samples over the concentration range outlined in Table 1 that can be extracted with an infrared-amenable membrane and measured by infrared transmission through the membrane. 1.2 This test method defines oil and grease in water as that which is extractable in this test method and measured by infrared transmission. 1.3 The method detection limit (MDL) and recommended reporting range are listed in Table 1. 1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D7575-11(2017) Referenced Document

ASTM D1129 Standard Terminology Relating to Water
ASTM D1193 Standard Specification for Reagent Water
ASTM D2777 Standard Practice for Determination of Precision and Bias of Applicable Methods of Committee D-19 on Water
ASTM D5847 Standard Practice for Writing Quality Control Specifications for Standard Test Methods for Water Analysis
ASTM E168 Standard Practices for General Techniques of Infrared Quantitative Analysis
ASTM E178 Standard Practice for Dealing With Outlying Observations

2017 ASTM D7575-11(2017) Standard Test Method for Solvent-Free Membrane Recoverable Oil and Grease by Infrared Determination
2011 ASTM D7575-11 Standard Test Method for Solvent-Free Membrane Recoverable Oil and Grease by Infrared Determination
2010 ASTM D7575-10e1 Standard Test Method for Solvent-Free Membrane Recoverable Oil and Grease by Infrared Determination
2010 ASTM D7575-10 Standard Test Method for Solvent-Free Membrane Recoverable Oil and Grease by Infrared Determination