ASTM D5028-17 PDF

Scope: 1.1 This test method covers determination of curing parameters of pultrusions resins by differential scanning calorimetry. 1.2 This test method is applicable to pultrusion resin solutions with adequate initiator(s). 1.3 The normal operating temperature range is from 0 to 200°C. NOTE 1—Resin systems that do not form an adequate baseline are not covered by this test method. 1.4 Computer or electronic based instruments or data treatment equivalent to this practice are suitable for use. 1.5 The values stated in SI units are to be regarded as standard. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Note 1. NOTE 2—There is no known ISO equivalent to this standard. 1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D5028-17 Referenced Document

ASTM D3418 Standard Test Method for Transition Temperatures of Polymers By Differential Scanning Calorimetry
ASTM D3918 Standard Terminology Relating to Reinforced Plastic Pultruded Products
ASTM D883 Standard Terminology Relating to Plastics*， 2024-02-01 Update
ASTM E2160 Standard Test Method for Heat of Reaction of Thermally Reactive Materials by Differential Scanning Calorimetry*， 2023-11-01 Update
ASTM E473 Standard Terminology Relating to Thermal Analysis
ASTM E967 Standard Practice for Temperature Calibration of Differential Scanning Calorimeters and Differential Thermal Analyzers

2017 ASTM D5028-17 Standard Test Method for Curing Properties of Pultrusion Resins by Thermal Analysis
2009 ASTM D5028-09 Standard Test Method for Curing Properties of Pultrusion Resins by Thermal Analysis
1996 ASTM D5028-96(2003)e1 Standard Test Method for Curing Properties of Pultrusion Resins by Thermal Analysis
2003 ASTM D5028-96(2003) Standard Test Method for Curing Properties of Pultrusion Resins by Thermal Analysis
1996 ASTM D5028-96 Standard Test Method for Curing Properties of Pultrusion Resins by Thermal Analysis