API MPMS 10.1-2007 Manual of Petroleum Measurement Standards Chapter 10 - Sediment and Water@ Section 1 - Standard Test Method for Sediment in Crude Oils and Fuel Oils by the Extraction Method (THIRD EDITION)
This test method covers the determination of sediment in crude oils and fuel oils by extraction with toluene. The precision applies to a range of sediment levels from 0.01 to 0.40 % mass@ although higher levels may be determined. NOTE 1??Precision on recycled oils and crank case oils is unknown and additional testing is required to determine that precision. The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. This standard does not purport to address all of the safety concerns@ if any@ associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific warning statements@ see 5.1.1.6 and 6.1. *A Summary of Changes section appears at the end of this standard.
2007API MPMS 10.1-2007 Manual of Petroleum Measurement Standards Chapter 10 - Sediment and Water@ Section 1 - Standard Test Method for Sediment in Crude Oils and Fuel Oils by the Extraction Method (THIRD EDITION)
2002API MPMS 10.1-2002 Manual of Petroleum Measurement Standards Chapter 10 - Sediment and Water@ Section 1 - Standard Test Method for Sediment in Crude Oils and Fuel Oils by the Extraction Method (Second Edition)
1981API MPMS 10.1-1981 Manual of Petroleum Measurement Standards Chapter 10 - Sediment and Water Section 1 - Determination of Sediment in Crude Oils and Fuel Oils by the Extraction Method (ASTM D 473)