T 164-2013
Standard Method of Test for Quantitative Extraction of Asphalt Binder from Hot Mix Asphalt (HMA)

Standard No.

T 164-2013

Release Date

2013

Published By

AASHTO - American Association of State Highway and Transportation Officials

Status

Be replaced 2018-09

Replace By

T 164-2014

Latest

T/CIET 164-2023

Scope

These methods cover the quantitative determination of asphalt binder in hot mix asphalt (HMA) and HMA pavement samples. Aggregate obtained by these methods may be used for sieve analysis using T 30. The values stated in SI units are to be regarded as the standard. This standard may involve hazardous materials@ operations@ and equipment. This standard does not purport to address all of the safety concerns associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazards are given in Section 8. Note 1-The results obtained by these methods may be affected by the age of the material tested@ with older samples tending to yield slightly lower asphalt binder contents. Best quantitative results are obtained when the test is made on HMA mixtures and pavements shortly after their preparation. It is difficult to remove all the asphalt binder when some aggregates are used; some solvent may remain within the mineral matter affecting the measured asphalt binder content.

T 164-2013 history

• 2023 T/CIET 164-2023 laser marking machine
• 2014 T 164-2014 Standard Method of Test for Quantitative Extraction of Asphalt Binder from Hot Mix Asphalt (HMA)
• 2013 T 164-2013 Standard Method of Test for Quantitative Extraction of Asphalt Binder from Hot Mix Asphalt (HMA)
• 2011 T 164-2011 Standard Method of Test for Quantitative Extraction of Asphalt Binder from Hot Mix Asphalt (HMA)
• 2010 T 164-2010 Standard Method of Test for Quantitative Extraction of Asphalt Binder from Hot Mix Asphalt (HMA)
• 2008 T 164-2008 Standard Method of Test for Quantitative Extraction of Asphalt Binder from Hot Mix Asphalt (HMA)
• 2006 T 164-2006 Standard Method of Test for Quantitative Extraction of Asphalt Binder from Hot-Mix Asphalt (HMA)
• 2005 T 164-2005 Standard Method of Test for Quantitative Extraction of Asphalt Binder from Hot-Mix Asphalt (HMA) (ASTM Designation: D 2172-01)
• 2001 T 164-2001 Standard Method of Test for Quantitative Extraction of Bitumen from Bituminous Paving Mixtures (HM-22; Part IIA; ASTM Designation: D 2172-88)
• 1997 T 164-1997 Standard Method of Test for Quantitative Extraction of Bitumen from Bituminous Paving Mixtures (Twentieth Edition; ASTM D2172-88)
• 1994 T 164-1994 Standard Specification for Extraction of Bitumen from Bituminous Paving Mixtures (Eighteenth Edition; ASTM D2172-88)