ASTM D6403-99(2020) PDF

Scope: 1.1 This test method is intended for use in determining the moisture content in raw and spent materials that are extracted for tannin analysis. The moisture content of the sample is operationally defined to be equal to the weight loss experienced as a result of the evaporation which occurs in the drying oven. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D6403-99(2020) Referenced Document

ASTM A6/A6M Standard Specification for General Requirements for Rolled Structural Steel Bars, Plates, Shapes, and Sheet Piling*， 2024-03-01 Update
ASTM D6405 Standard Practice for Extraction of Tannins from Raw and Spent Materials

2020 ASTM D6403-99(2020) Standard Test Method for Determining Moisture in Raw and Spent Materials
1999 ASTM D6403-99(2014) Standard Test Method for Determining Moisture in Raw and Spent Materials
1999 ASTM D6403-99(2009) Standard Test Method for Determining Moisture in Raw and Spent Materials
1999 ASTM D6403-99(2004) Standard Test Method for Determining Moisture in Raw and Spent Materials
1999 ASTM D6403-99 Standard Test Method for Determining Moisture in Raw and Spent Materials